Clean powerup and channel switching without interference to others
Miniature and light weight design
Frequency(Mhz)
Band
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
A
5865
5845
5825
5805
5785
5765
5745
5725
b
5733
5752
5771
5790
5809
5828
5847
5866
c
5705
5685
5665
5645
5885
5905
5925
5945
d
5740
5760
5780
5800
5820
5840
5860
5880
E
5658
5695
5732
5769
5806
5843
5880
5917
F
5362
5399
5436
5473
5510
5547
5584
5621
Key configuration:
After power on,press and hold the button to enter (configuration mode) channel number, channel group and power.
1.press and hold the button until the red light flashing , adjustable channel frequency (1,2,3,4,5,6,7,8).
Short press the button at this time, you can switch the channel frequency. The blue light flashes to indicate channel frequency 1, blue light flashes a few times to express corresponding channel frequency
2.Press and hold the button until the red light flashing twice, adjustable channel group (A, b, c, d, E, F).
Short press the button at this time to switch the channel group. Blue light flashes for channel group A The number of blue lights flashes each increment and then, it is expressed as (b, c, d, E, F).
3 Press and hold the button until the red light flashing three times, you can adjust the power. Short press the button to switch the power, blue light flashes that 25mw, two flash 100mw, three flash 200mw.
4. press and hold the button finish parameters setting, red, blue keep on.
5. Press the button twice quickly, when the red light is always on, the blue light off means the RF is off. Press twice quickly, when the red light,the blue light on means the RF is on.
Package Included
1 x EWRF e7082C 25mW/100mW/200mW/OFF 5.8G 48CH Transmitter
Be the first to review “EWRF e7082C Pro 0mW/25mW/100mW/200mW/OFF Switched 5.8G 48CH VTX FPV Transmitter Support Pitmode OSD Configuration” Cancel reply
There are no reviews yet.